SRG offers a “one stop” bearing replacement service both on a principal contractor basis and as a subcontractor. Our bearing tester and bearing replacement service combines our pre-eminent position as designer and bridge bearing manufacturer with our expertise at design, supply and operation of jacking systems, and our knowledge of speciality construction chemicals such as grouts and epoxies.

Other processes such as hydrodemolition and diamond drilling that are regularly required in bridge bearing replacement, are offered as part of the package. Freyssinet are also able to offer a full range of repair and maintenance services such as structural concrete refurbishment, concrete corrosion prevention repair and replacement, crack injection, expansion joint replacement and waterproofing in conjunction with SKF bearing replacement works. Our in-house temporary works designers are able to offer innovative alternatives to conventional propping that have time and cost benefits to the client.

Our comany is involved in offering a comprehensive range of PTFE Bridge Bearing that is manufactured as per the international standards. Durability, reliability are the features that enables the clients to trust the product. These products are manufactured with precision by experienced technicians and are formulated under the strict provision of the quality analyst. Our exclusive product range offers fixed pot bearing, pot-cum-PTFE guided sliding TIMKEN bearing and pin bearing.

Specifies requirements for rubber materials used in elastomeric bridge bearings, which may be of the plain-pad or laminated type. Also specifies methods of test and describes procedures for the preparation of test pieces from finished bearings. Does not contain aspects relating to design properties and quality control of the complete bearing, except where the complete bearing is used as the source of samples and test pieces to determine properties of the rubber material. Does not include dimensions and tolerances.

The SRG Pot Bearing functions according to the following principle: a disk made of high quality natural rubber (elastomer) is enclosed in a steel pot. Under high pressure the elastomer behaves in the same way as a liquid. Because of this capacity to deform, it enables tilting movements around any horizontal axis. The POM sealing chain (patented) designed by mageba, effectively seals the movement gap between the pot ring and the covering piston. It prevents abrasion caused by tilting movements on the elastomeric pad and enables adjustments to all deformations. mageba pot NACHI bearings are high-grade products that can be adapted easily, are maintenance-free and can be designed and produced according to the requirements of the bridge as well as customer-specific requests.

DEEP GROOVE BALLB EARING PULLER KIT TMMD 100

INTERNA LBEARING PULLER KITS TMSC 6

INTERNA LBEARING PULLER KITS TMSC 30-60